Installation box ALPEX-GAS
Code: IVAGIK2812Product detailed description
Installation box ALPEX-GAS IVAR IKAG.
- recommended use in the ALPEX-GAS system
- installation box type INST 2812, allows installation of all variants of IVAR.PRESS-GAS compression fittings
- gas-tight sealing with the preparation IVAR.BUTYPLAST 5 N
- specification: 180 x 145 x 85 mm
Note: in the case of branching the gas pipe below ground level using the IVAR.PRESS-GAS T-piece, it is necessary to place the fitting into a suitable plastic box (e.g. type INST 2812), where it will be possible to gas-tightly seal the transition of the protective sleeve into the installation box with a butyl rubber seal, so that any gas leak can be detected according to the principles described above.
Recommended use according to PTN 704 05.
Additional parameters
| Category: | accessories |
|---|---|
| Warranty: | 2 years |
| Weight: | 0.5 kg |
Product rating
Be the first who will post an article to this item!
Discussion
Be the first who will post an article to this item!
|
|
IVAR CS spol. s r.o. was founded in 1992 as a trading company with a total of 5 employees and premises covering 3,500 m2. Over the past 25 years this small trading company has become a modern, dynamic company with a major influence on the sale of plumbing and heating installation products in the Czech and Slovak Republics. It acts as the sales and technical representative of a number of European companies operating in the fields of water, heating, gas, water filtration and treatment, pumping technology, solar systems, heat pumps, storage tanks, fan coil units, air conditioning and heat recovery ventilation. |
 |
You can download the IVAR CS price list HEREPrices valid from 1 September 2025
|