AVANSA 2007 TX
Code: BEZDROTOVY TERMOSTAT AVANSA 2007TXRelated products
Product detailed description
Wireless programmable weekly thermostat AVANSA 2007 TX.
The wireless thermostat Avansa 2007 TX is suitable for the regulation of most boilers.
The thermostat can be connected to any gas boiler that has a connection for a room thermostat with a double wire connection.
The device can be connected to an air conditioning unit regardless of whether the unit has an operating voltage of 24V or 230V.
The device can be programmed according to your needs so that the heating (cooling) system starts at the time and at the temperature you require.
It allows not only to ensure comfort, but also to contribute to the reduction of energy costs.
It is possible to set 6 different switching-on times (in steps of 10 minutes) for each day and with freely adjustable temperature (in steps of 0.5 °C) for each of the six switching-on times.
The device consists of two units. One portable control unit (thermostat) and one receiving unit that is used to control the boiler. The connection between the thermostat and the receiver is ensured by radio frequency waves, so it is not necessary to install wiring between the thermostat and the boiler. Both units are pre-set by the manufacturer to operate on the same frequency.
The thermostat and the receiver have their own security code.
For this reason, unknown external radio frequency signals cannot interfere with the safe operation of the device.
The mobility of the thermostat has the following advantages:
- it is not necessary to install wiring, which is particularly advantageous during the renovation of old buildings
- the optimal placement of the thermostat can be chosen during use
- the use of the thermostat is suitable even in cases where there is an interest in using the device in different rooms during different time periods of the day
The sensor built into the thermostat has a range of approximately 50 m in free space.
This distance can be significantly reduced in a building, especially in cases where iron structures or reinforced concrete walls interfere with the radio waves.
The optional switching sensitivity is ± 0.2 °C (recommended basic setting by the manufacturer for radiator heating) or +0/-0.2 °C (recommended setting for floor heating).
These values refer to the temperature difference that occurs between the set temperature and the actual measured temperature in the room at the moment the thermostat is switched on.
For example, in the case of the basic setting by the manufacturer at a temperature of 20 °C, the device will switch on the boiler when the temperature reaches 19.8 °C or lower, or switch it off when the temperature reaches 20.2 °C or higher.
The thermostat can be optionally expanded with a socket type Avansa TX, which allows you to control any electrical device with an operating voltage of 230V (e.g. boiler, pump, electric heater) without any installation.
The thermostat is equipped with a pump protection function.
This function is used to prevent the pump from clogging.
The device switches on the boiler every day at 12:00 for one minute, provided the boiler has not been switched on according to the program for more than 24 hours.
If for any reason (e.g. power failure) the power supply to the receiver is interrupted, the operation of the boiler is also suspended.
Technical data of the thermostat:
- temperature measurement range: 0-35 °C (in steps of 0.1 °C)
- adjustable temperature measurement range: 7-35 °C (in steps of 0.1 °C)
- accuracy of measured temperature: ± 0.5 °C
- switching sensitivity (radiator heating): ± 0.2 °C
- switching sensitivity (floor heating): +0/-0.2 °C
- recommended storage temperature: -10 °C.....+ 60 °C
- supply voltage: 2 x 1.5V batteries (type LR6; AA)
- power consumption: 1.3 mW
- dimensions: 130 x 80 x 35 mm (without bracket)
- weight: 155 g
- type of thermal sensor: NTC 10 KΩ ± 1% at 25 °C
- protection class: IP 30
Technical data of the receiver:
- power consumption: 6W
- supply voltage: 230V AC, 50 Hz
- connection voltage: 24V AC/DC...250V AC
- adjustable current intensity: 6 A (inductive load 2A)
- range: approx. 50 m
- weight: 150 g
- total weight of the device: approx. 500 g (thermostat + receiver + bracket)
Example of connecting a circulation pump:
Additional parameters
| Category: | wireless and internet |
|---|---|
| Warranty: | 2 years |
| Weight: | 0.6 kg |
Inštruktážne video
Product rating
Be the first who will post an article to this item!
Discussion
Be the first who will post an article to this item!